Straight Microduct Connector With metal-ends

Technical Parameters

Ø Working Pressure:16 Bar (For Air Blown Fiber System)

Ø Working Temperature: -20℃~+50℃

Ø Fluid: Compressed Air

Ø Lifespan:20 Years

Ø  Standards: EN50411-2-8

Material

Ø  Body: Polycarbonate

Ø  Seal: NBR

Ø  Washer: Polyacetal

Ø  Lock Claws: SUS

Ø Collar: Polyacetal

Ø  Sleeve: Polyacetal

Notes

Ø Please confirm the microduct outer diameter whether has damaged or scratches, connection face   must be clean.

Ø Please confirm the microduct outer diameter nominal tolerances meets±0.1 mm.

Ø Please make sure the connection micro duct end face is cut into rectangular plane.

Ø Please confirm the microduct should be through the sealing ring, have been pushed to the end of the joint, until it couldn't go far again.

Ø After connecting the microducts, must check whether the duct can pull, then put into use.

Ø When disassemble the microducts, please make sure the pressure is 0.

Description

Ø Connect two microducts which are the same outer diameter

Ø Easy installation, without any special tools

Ø Transparent plastic body, easy to observe the situation

Ø High temperature resistance -40℃~65℃

Ø High pressure resistance>25bar

Ø Standard EN50411-2-8